Fenix ​​TK20R V2.0 3000 LM TK20RV20

Tactical rechargeable flashlight Fenix TK20R V2.0 offers a light output of up to 3000 lumens (ANSI), charging via modern USB-C connector, and the ability to activate the strobe mode instantly. It is equipped with the top-notch LED Luminus SFT-70, which creates a well-focused light cone with a range of 475 meters. The package includes a 21700 Li-ion battery with a capacity of 5000 mAh, which can be charged directly in the flashlight via the USB-C connector. The charging port is covered by a screw cap, making it perfectly protected against water and dirt. The Fenix TK20R V2.0 flashlight uses a dual tactical switch, allowing for faster and more reliable control in crisis situations. It can be directly switched to the strobe mode. The flashlight has a total of six lighting modes with a runtime of up to 48 hours. Thanks to its robust construction, the flashlight is sturdy while maintaining a compact size. The sturdy design allows for the flashlight to be used on long weapons, making it suitable for professionals, armed forces, and hunting.

6 power modes:
3000 lumens (2.8 hours) -> 1000 lumens (3.1 hours) -> 350 lumens (7 hours) -> 150 lumens (21.3 hours) -> 30 lumens (48 hours) -> 3000 lumen strobe.

Fenix TK20R V2.0 tactical light parameters:
- Powerful Luminus SFT-70 LED with a lifespan of 50000 hours.
- Parabolic reflector for a light cone with a range of up to 475 meters (56600 cd).
- 1x rechargeable 21700 Li-ion battery with a capacity of 5000 mAh (included in the package).
- Charging via sealed USB-C connector with battery charging status indication.
- Electronics with digital power regulation and overheating protection.
- The flashlight has a mode memory (turns on in the last set mode, excluding the strobe mode).
- Impact-resistant up to 1.5 meters.
- Trapezoidal threads highly resistant to wear.
- Hard-anodized surface that is resistant to scratches - Type III hard anodized.
- Waterproof and dustproof according to IP68 standard.
- Dual tactical switch at the end of the flashlight (instant on/off function - momentary on/off).
- Sturdy clip for secure and easy carry (removable).

There may be a black insulating cover inside the flashlight on the battery. Remove it from the battery before first use.

To turn on the flashlight, press the larger tactical button located at the end of the flashlight, to activate the flashlight instantly, press the button firmly. By pressing the secondary switching button, you can switch between power modes at any time during operation. To switch to strobe mode with the flashlight turned on, hold the switching button for about 0.5 seconds. To turn on the flashlight directly into the strobe mode, press and hold the switching button.

Battery status indication - the charging indicator is hidden under the protective nut of the charging connector for tactical reasons, so it is necessary to unscrew the nut to check it. The flashlight always indicates the battery charging status three seconds after turning on. Green indicates sufficient battery charge (100% - 85%), green blinking (85% - 50%), steady red (50% - 25%), and blinking red indicates critically low battery charge (25% - 1%). When the battery is fully discharged, the flashlight will automatically switch to lower power modes, and in the lowest mode, it will flash 3 times every five minutes.

Flashlight charging - Unscrew the protective nut below the head of the flashlight and connect it to a computer, a USB power adapter, or a car USB adapter using the included USB-C cable. It is also possible to use any mobile phone charger with a USB-C connector for charging. During charging, the LED indicator opposite the charging connector will glow red, and after full charging, it will glow green. Charging a fully depleted battery takes approximately 3.5 hours. The Li-ion battery used does not suffer from memory effect, so the flashlight can be recharged at any time. It is not possible to turn on the flashlight while it is charging.

Warning
- Use only high-quality 21700 Li-ion batteries to prevent damage to the flashlight, such as leakage of substances from the battery.
- Insert the batteries with the positive pole facing towards the head of the flashlight.
- If the protective rubber rings appear damaged after prolonged use, replace them. The rings should be lubricated to prevent rubber erosion. By following these rules, the flashlight will be properly protected against water.

If the flashlight blinks, does not switch to higher power modes, or does not turn on, it may be due to one of the following reasons:
- The battery is almost depleted - charge it.
- Contacts inside the flashlight are dirty - clean them with a cotton swab soaked in alcohol.
- The rear part of the flashlight is loose, tighten it.

The flashlight comes with a wrist strap, a belt holster, a spare o-ring, a USB charging cable, and the Fenix Li-ion 21700 5000 mAh battery.

Optional accessories available for purchase include the AER-05 cable switch, the AOT-M traffic wand, the AOF-M red filter, and the AOD-M diffuser.

The following accessories are also compatible with the flashlight: ALG-00 quick-release rail mount, Fenix ALG-16 M-LOK mount, Fenix ALG-18 barrel mount, mount for optics, metallic magnetic barrel mount, plastic magnetic barrel mount, bicycle mount FB-1, Fenix bicycle mount, ALP-10L holster.

The flashlight can also be further supplemented with a USB wall adapter and a USB car adapter.